|
Vulcan hammers are designed in "families" of accessory sizing that are designed for maximum adaptability of accessories to a wide variety of hammers. Below is a guide to that interchangeability. While we can verify the compatibility of Vulcan and Raymond accessories, the guide to the Conmaco accessories is just a guide and we cannot accept responsibility for problems arising from the mating of our accessories with their hammers and vice versa. |
| Accessory Family |
Vulcan Hammers |
Raymond Hammers1 |
Conmaco Hammers3 |
| #1 Type Hammers (11 1/4 or 11 1/2" Diameter Cushion Pot) |
#1, 06, 306, 505, 506, 50C, 65C |
#1, 1-S, 50CX, 65C2 |
50, 65, 50E5, 65E5 |
| #0 Type Hammers (13 3/4" or 14" Diameter Cushion Pot, Tapered Cone) |
#0,0R, 08, 010, 012, 508, 510, 512, 65CA, 80C, 85C, 100C |
2/0, 3/0, 4/0, 5/0 (Keyed Hammers), 80C Modified Vulcan2 |
80, 100, 125, 80E5, 100E5, 125E5 |
| "95100" Type Hammers (14" Diameter Cushion Pot, Straight Base Receptacle) |
3/0 Cable, 80C Raymond, 80CH |
||
| 014 Type Hammers |
014, 016, 140C |
140, 160 |
|
| 020 Onshore Type Hammers (19" Diameter Pot) |
020 and 030 Onshore |
||
| 020 Offshore Type Hammers (22 1/4" Diameter Pot)> |
020, 030, 530 Offshore; 520, 530 Onshore |
200, 300, 200E5, 300E5, 5300 |
|
| 150C Type Hammers |
100CX, 125CX, 150C, 30X, 40X, 60X |
|
Notes: 1 All Raymond Hammers were designed to use the Raymond Capblock Shield; these are available from Vulcan. Most Raymond 65CH (and some 65C) hammers used a capblock shield that was integral with the base. 2 Raymond Hammers in this series can always use the Vulcan accessories but Vulcan hammers cannot always use Raymond accessories. 3The guide to the Conmaco accessories is just a guide and we cannot accept responsibility for problems arising from the mating of our accessories with their hammers and vice versa. |
|
|
a subsidiary of Pile Hammer Equipment Corporation
|
Vulcan
Foundation Equipment
|
Copyright © 2001-2010 Vulcan Foundation Equipment. All rights reserved.
|
||
