Wave Equation Request

As a service to its customers, Vulcan Foundation Equipment can perform drivability and wave equation analyses for impact hammers. However, there are certain information items that Vulcan requires and certain limitations in the scope and use of these studies that contractors and owners alike should be made aware of.

All drivability and wave equation analyses are subject to the following disclaimer, which should be understood from the beginning:

ATTENTION

THE ATTACHED FINITE DIFFERENCE WAVE EQUATION AND OTHER ANALYSES ("THE ANALYSES") ARE INTENDED EXCLUSIVELY AS A FIRST ESTIMATE OF THE PERFORMANCE OF THE REFERENCED HAMMER UNDER THE STATED CONDITIONS. THE ANALYSES ARE NOT A SUBSTITUTE FOR A COMPLETE GEOTECHNICAL ANALYSIS WHICH SHOULD BE UNDERTAKEN BY THE CUSTOMER.

THE ANALYSES ASSUME THE EXISTENCE OF CERTAIN CONDITIONS WHICH ARE EXPECTED TO VARY FROM THE ACTUAL CONDITIONS OF EACH PROJECT. THE VARIANCE BETWEEN ASSUMED CONDITIONS AND ACTUAL PROJECT CONDITIONS IS POTENTIALLY SIGNIFICANT.

VULCAN FOUNDATION EQUIPMENT ASSUMES NO RESPONSIBILITY FOR THE ACCURACY OF THE ANALYSES OR THE VARIANCE BETWEEN THE RESULTS PREDICTED BY THE ANALYSES AND THE RESULTS ACHIEVED UNDER ACTUAL PROJECT CONDITIONS.

THE CUSTOMER SHOULD RELY ON THESE ANALYSES ONLY AS A FIRST EVALUATION OF THE PROJECT. ANY OTHER USE OF THE DATA IS NOT ADVISED.

Users of the data should also understand that the reports are not sealed.

Need information on pile driving in general? Visit vulcanhammer.net.

Required Information

The following information is required for a drivability analysis. You will also be asked to submit detailed soil boring information as well.

1) Basic Job Site Information

Location of Job

Contractor

Owner or Contracting Authority

Email address

2) Hammer Information

Hammer Intended (if known; range of hammer size if not.) Only Vulcan hammers can be analysed.

Cushion Material and Cushion Pot Configuration intended.

Any special Hammer requirements (leaders, accessories, limitations of crane or air compressor, etc)

3) Pile Information

Pile material(s) (steel, concrete, wood, plastic, etc.)

Pile type (H-beam, sheeting, square concrete, pipe, etc.)

Pile length(s)

Pile Batter, if any.

Tip elevations of piles at maximum penetration.

Design axial capacity of piles, both downward and uplift (the latter if available)

Information on driving specifications, and specifically whether piles are being driven to capacity or tip elevation.

Pile end protection (pile points)

Existence of stingers, if any.

Shared Bottom Border

a subsidiary of Pile Hammer Equipment Corporation
Click here to visit
Vulcan Foundation Equipment
1297 Scenic Highway
Rising Fawn, GA 30738
Phone (706) 398-1178
Fax (706) 398-1178
Copyright © 2001-2010 Vulcan Foundation Equipment. All rights reserved.
This site maintained by Positive Infinity